WebPage 120: Printing The Test Pattern TROUBLESHOOTING 8.5.3 Printing the Test Pattern Print a self-test pattern to check the operation of the plotter. Operation (1) Set a paper larger than A3 size. (2) Set the pen tool to the tool carriage and select the condition where the pen tool is set. (3) Press the [MENU] key to display the menu below. WebGRAPHTEC AMERICA PROFESSIONAL RESOURCES
If Your Graphtec Cutter is Not Reading the Marks
WebSensor Adjust Cross-hair Pattern - pdf (424 KB) > Download Video: The cross-mark pattern is printed on vinyl, and blade is used to calibrate to increase accuracy, recommended. This procedure can also be used to isolate the cutter when scan mark errors occur. If sensor sucessfully reads the pattern, means the sensor is working normally. WebPage 113: Service Mode. Operation status can be tested by self diagnostic test with operating the sensors and switches following the instruction on the screen. Operation (1) Turn on the CE LITE-50. (2) Holding down the power button while the power is on. (3) Select "DIAGNOSTICS" on the TEST screen. bj\u0027s wholesale revere ma
PRINT & CUT Issues and Solutions for the FC9000 Series
WebMay 14, 2024 · So you are going to have to calibrate the ARMS sensor most likely- see manual. Also check the manual for paper weight, and test with both On and OFF. (I would post the CALIBRATION sheet that I used for an FC7000, but cant find it-- contact Graphtec support in CA they have it ready to print. Also I found better success with TYPE 2 Marks. … http://www.graphteccorp.com/product/fc9000/support.html http://www.graphteccorp.com/support/software/cuttingplotters.html bj\u0027s wholesale stock price